Schematic Water Pressure Booster Pump Tank Systems

After the sump tank an overhead tank is installed to act as reservoir of the water that is siphoned by the booster pump from the said sump tank.

Schematic water pressure booster pump tank systems.

When a pump first starts up it sucks water from the pipes. In a rain harvesting system for example water collects in a storage tank. The water tank and pump are connected into the main water supply to the property. Pump must be located within 2 feet of pressure switch and within 6 feet of power outlet.

Most well water is pumped out of the ground automatically using a submersible pump or a jet pump that sits on top of the ground and draws water out of the ground to create water pressure for the home. Our photo at page top shows a typical water pressure booster pump and tank system for sale at don pedro s ferreteria in san miguel de allende. The incoming community water supply line which normally is fed through a pressure regulator and into building supply piping is first connected to a water pump usually a 1 line jet pump. Some well water systems use a large storage tank to store the water before it is pumped again to the house.

Stainless steel booster pump 1 0 hp 220v 60hz corrosion proof select your voltage options. Bladder tanks are perfect to use before pumps. We recommend that a licensed contractor install all new systems and replace existing pumps and motors. See diagram on back for where to place the pressure switch.

Pumps are damaged when they operate with the initial low pressure that happens normally. Technically qualified personnel should install pumps and motors. Failure to install in compliance with local and national codes and manufacturers recommendations may result in electrical shock fire hazard unsatisfactory performance and. I need the standard 220v 60hz i need 220v 50hz pump for outside u s.

The typical installation consists of a booster pump and back up water tank the pump and water tank need to as close together as possible and a power supply will have to be installed at the chosen site for the pump and tank. A booster pump is also used to re pressurize water from a storage tank and send it to a faucet or throughout a home. When either the pressure switch or pressure sensor turns on the booster pump it pulls water from the storage tank to supply the pressure tank that in turn supplies the house or irrigation system. Booster pump installation instructions 1.

The booster pump should be installed after the water meter of the water service connection provided that a sump tank should be positioned before the booster pump. Install pressure switch in tank line. Placing a bladder before a pump can help reduce this damage and can cure systems with frequent low pressure alarms due to fluctuating line pressure.